A very important part of the LokSound system is the speaker. Therefore, we only use specially developed loudspeakers geared to the sound decoder. Here we recommend the following old saying, the bigger the speaker, the better the sound. As such, we offer loudspeakers in various sizes, one of them will surely fit into your loco. Should there not be enough space, you can also install the speaker in a ‘ghost waggon’ directly behind the loco.
Another crucial accessory is the sound chamber. This helps create the necessary sound pressure for the speaker´s membrane and comes with most loudspeakers.
If you are not sure about which loudspeaker fits into your loco we generally recommend to open the loco and measure the dimensions with a ruler.
Since model railway manufacturers often tend to change (tacitly) the inner modifications of their locos we are not able to make recommendations in general. Therefore rely on your own observations!
You must never use the new 4 Ohms speakers with the previous LokSound V3.5 decoder. The decoder could be destroyed! When the decoder is replaced, the speaker must! be changed as well.
At 13mm x 18mm, this new ‘sugar cube’ loudspeaker is larger than the speaker previously known from ESU.
As the diaphragm is therefore a good 40% larger, it can produce significantly higher sound pressure levels. Bass, midrange, and treble reproduction are flawless. This speaker can be used anywhere our bass reflex speakers don't have space, but where the best possible bass reproduction is still important. The same applies to our new speaker: the larger the sound chamber, the better the sound. We supply 4 sound chambers of different heights in the set. With the speaker mounted (hermetically sealed!), the total height is 17.5mm, 12.5mm, 9.5mm or 7.5mm.
